2V0-602 Exam Dumps | What will happen to the…

Questions: 14

What will happen to the VM when a vSphere Administration returns to a snapshot that was created without memory on the running VM?

A. VM will be rebooted
B. VM will be running in the state that it was at the time the snapshot creation
C. VM will be powered on
D. VM will be powered off

Answer: D

2V0-602 Dumps | What three steps must be…

Questions: 11

What three steps must be taken when removing a host from a vSAN-enabled cluster? (Choose three.)

A. Remove disks from diskgroups, remove disk groups.
B. Create at least one vSphere Standard Switch.
C. Remove VMKernel port with vSAN traffic checkbox checked.
D. Remove the host from vSAN cluster.
E. Place the host into maintenance mode with Full Migration option selected.

Answer: CDE

2V0-602 | Which statement is a requirement for Storage…

Question: 8

Which statement is a requirement for Storage vMotion?

A. The source and destination VMDKs must be of the same provisioning type.
B. The virtual machine cannot contain any raw device mappings (RDMs).
C. Virtual disks must not be larger than 2TB.
D. The host on which the virtual machine is running must have access to the source and target datastores.

Answer: D

2V0-602 | A virtual machine loses network connectivity after…

Question: 7

A virtual machine loses network connectivity after vMotion. Which two troubleshooting tasks can be performed? (Choose two.)

A. Verify virtual switch option Notify Switches is set to Yes.
B. Ensure that Enhanced vMotion Compatibility has been configured.
C. Change the teaming policy to active/standby mode.
D. Ensure that the virtual machine is in the proper VLAN ID.

Answer: A, D

2V0-602 | What three steps are necessary to enable Jumbo…

Question: 6

What three steps are necessary to enable Jumbo Frames for use with an iSCSI storage array? (Choose three.)

A. Configure the MTU on the physical switch.
B. Configure the MTU on the virtual switch.
C. Configure the MTU on the VTEP.
D. Configure the MTU on the LAG group.
E. Configure the MTU on the VMKernel port.

Answer: B,D,E

2V0-602 | Which two options can be used for vCenter…

Question: 5

Which two options can be used for vCenter Server 6.x database availability? (Choose two.)

A. NSX load balancer
B. Microsoft SQL Server 2012/2014 AlwaysOn Availability Groups (AG)
C. vCenter Server Watchdog
D. vCenter Server Heartbeat
E. Microsoft Windows Server Failover Clustering

Answer: C, D

Leave a Reply

Your email address will not be published. Required fields are marked *