VCPC610 | An administrator is installing ESXi…

Question: 18

An administrator is installing ESXi 5.x to a local SAS drive. The installation stops on a purple screen and shows the error:
The system has found a problem on your machine and cannot continue. Could not populate the filesystem:
Admission check failed
Which action should the administrator take to resolve this issue?

A. Upgrade the ESXi host to meet the minimum hardware requirement for installation.
B. Disable the network interface cards (NICs) to ensure that third-party drivers do not interfere with installation.
C. Enable hardware Virtualization Technology in the ESXi host BIOS.
D. Disable the Host Bus Adapters (HBA) to ensure the installation targets the local disk.

Answer: A

VCPC610 | An administrator needs to deploy several…

Question: 17

An administrator needs to deploy several virtual machines. Storage contention between the virtual machines should be managed by the VMkernel. Some of the virtual machines will use MSCS and should be highly available across the ESXi 5.5 hosts. Which two storage options meet these requirements? (Choose two.)

A. iSCSI
B. NFS
C. Fibre Channel
D. VSAN

Answer: A,C

VCPC610 | An administrator determines that when a host…

Question: 16

An administrator determines that when a host residing in a High Availability (HA) cluster fails, the virtual machines fail to restart on a remaining host, or will only restart after a long delay. Which two conditions would account for this behavior? (Choose two.)

A. The virtual machines were not protected by vSphere HA at the time the failure occurred.
B. Distributed Resource Scheduler was not enabled at the time the failure occurred.
C. There is insufficient spare capacity on hosts with which the virtual machines are compatible.
D. The virtual machines contain physical Raw Device Mappings.

Answer: A,C

VCPC610 | Immediately after installing an ESXi host…

Question: 15

Immediately after installing an ESXi host, an administrator needs to examine the following log files:
/var/log/hostd.log
/var/log/vmkernel.log
/var/log/vpxa.log
Which two techniques could an administrator use to examine these files? (Choose two.)

A. Using the Direct Console User Interface
B. Attaching a vSphere Client directly to the ESXi host
C. Attaching the vSphere Web Client directly to the ESXi host
D. Attaching the vSphere Client to the vCenter Server

Answer: A,B

VCPC610 | A vSphere administrator creates a new vSphere Distributed…

Question: 14

A vSphere administrator creates a new vSphere Distributed Switch. The administrator receives notice from the service desk that a cluster of vSphere hosts has disconnected from vCenter Server. This disconnect occurred immediately after the new switch was created. This vSphere Distributed Switch is the only distributed switch managed by vCenter Server. The virtual machines are still functional and the applications are still accessible by end users. On the ESXi hosts, which step must the vSphere administrator take to allow vCenter Server to reconnect?

A. Use the Direct Console User Interface to reattach the management vmnic to the appropriate switch
B. Use the Direct Console User Interface to disable lockdown mode on each affected host
C. Use the ESXi Shell to restart the mgmt-vmware service on each affected host
D. Use the ESXi Shell to restart the vSphere Web Client service on each affected host

Answer: A

VCPC610 | A vSphere administrator needs to increase the capacity…

Question: 13

A vSphere administrator needs to increase the capacity of an existing Storage Distributed Resource Scheduler (SDRS) datastore cluster. The storage administrator has provisioned two new NFS datastores
to be added to the cluster. The vSphere administrator receives an error message, preventing the administrator from adding the newly provisioned datastores to the cluster. What is the likely reason that the action failed?

A. There are virtual machines running on the datastores being added to the cluster.
B. The datastores in the SDRS cluster are VMFS datastores.
C. The datastores in the existing cluster have hardware acceleration enabled and the new datastores do not.
D. The SDRS cluster has not been placed into maintenance mode.

Answer: B

VCPC610 | An administrator is considering using NPIV…

Question: 11

An administrator is considering using NPIV to assign WWNs to virtual machines. Virtual machine portability is a major concern. Why would NPIV be inappropriate for this deployment?

A. Virtual machines using NPIV must use DirectpathIO.
B. Storage vMotion is not supported using NPIV.
C. vMotion is not supported using NPIV.
D. Enabling NPIV requires SR-IOV supported hardware.

Answer: B

VCPC610 | An administrator is considering using…

Question: 10

An administrator is considering using NPIV to assign WWNs to virtual machines. Virtual machine portability is a major concern. Why would NPIV be inappropriate for this deployment?

A. Virtual machines using NPIV must use DirectpathIO.
B. Storage vMotion is not supported using NPIV.
C. vMotion is not supported using NPIV.
D. Enabling NPIV requires SR-IOV supported hardware.

Answer: B

VCPC610 | A business group administrator is assigned

Question: 9

A business group administrator is assigned to build three blueprints each with the same twenty custom properties. What would be the best approach to avoid mistakes with custom property entry?

A. Create a build profile that includes the custom properties.
B. Create a custom property macro that includes the custom properties.
C. Create a property group that includes the custom properties.
D. Create a property profile that includes the custom properties.

Answer: A

Leave a Reply

Your email address will not be published. Required fields are marked *